JMS Performance Progressive Nitrous Controller

JMS Performance Progressive Nitrous Controller

$404.99Promotion Price:
MSRP:$511.98
Total Savings:$106.99(21%)
Available
FREE SHIPPING
Part Number:13605

Fitment:

1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982

Fitment:

1984 1985 1986 1987 1988 1989 1990 1991 1992 1993 1994 1995 1996 1997 1998 1999 2000

Fitment:

2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019
JMS Performance Progressive Nitrous Controller:

The Progressive Nitrous Controller that is designed to outperform.

The JMS Progressive N20 Controller is the new standard for Nitrous Controllers. Finally, there is a N20 Controller that allows for maximum adjustability while combining all of the popular nitrous add-ons into one device. No external relays, triggers or RPM Switches required...it’s all in one device.

Easy to setup and use. No relays, triggers, or RPM switches required, everything is built into one unit.
  • Compatible with all 12V or 16V battery systems & one to sixteen cylinder engines.
  • Adjustable Solenoid Frequency
  • Wide-Open Throttle Enable Trigger
  • Wide-Open Throttle Enable Trigger
  • Dual Independent Ramp Rates
Simple Installation:
  • Easy to setup and use.  No need for a laptop or complicated user display.  All adjustments can be made with the included flat-head screwdriver
  • Complete Progressive Nitrous System Control in a single unit: eliminate external relays, triggers and RPM switches
Case/Enclosure Specifics and Dimensions:
  • Silver, Aluminum Case with four mounting tabs
  • Length:  5 1/2", Width:   2 1/2", Height:  1 1/2"
Operating Voltage Range:
  • 9.5V - 20V DC
Compatibility:
  • Works with all 12V or 16V battery systems
  • Supports all engines from one to sixteen cylinders, four stroke or two stroke
  • Automatically functions as a Turbo Nitrous Controller, if the start percentage is set higher than the end percentage
Inputs:
RPM:  Monitors Engine RPM.  Connect to the negative side of the ignition coil or fuel injector.
  • Wide Open Throttle Enable Trigger:
  • Trigger (1) :  Ground Enable, typically connected to a micro-switch and grounded at WOT.
  • Trigger (2):   0-5V DC (invertible), typically connected to a Throttle Body TPS.
Notes:  Either WOT Trigger may be used to enable the controller. The enable voltage must be set by the user.

Tire Spin /Gear Lock Out:  
  • Ground Enabled: Typically connected to a micro-switch
  • Depending on when this input is grounded:  can either manually lock the controller OFF or can be used to enable a second progressive ramp rate setting
Outputs:
  • 55amp maximum combined fuel & nitrous solenoid output
  • +12V timing retard output, 50mA, short circuit protected
Adjustable Solenoid Frequency:
  • 12.5hz, 20hz, 25hz, 40hz  (special solenoids are required for 40hz)

Independent Fuel and Nitrous Solenoid Control:
  • Increased amperage capacity
  • Improved solenoid accuracy and control
Fuel Solenoid Settings:
The fuel solenoid output can be independently modified to control activation lean spikes.
  • 100% duty cycle
  • 85% duty cycle for the initial 0.5 seconds after activation and then matches the Nitrous Solenoid Output
  • 75% duty cycle for the initial 0.3 seconds after activation and then matches the Nitrous Solenoid Output
RPM Window Switch:
Minimum RPM to enable Nitrous Output:     1000 RPM
Maximum RPM to disable Nitrous Output:  16,900 RPM

12V Timing Retard Output:
+12v output when the Nitrous Output is active
Designed to be connected to an ignition box timing retard input.

Installation Kit:
3 feet of power/solenoid wiring, wiring harness, heat shrink connectors, heat shrink ring terminal, self-taping screws, tie straps

Reward Points

405 points will be rewarded to you when you buy this item.

Related Items

Recently Viewed Items